Omnipure CL Series CL6PF & CL10PF 5 & 25 Micron In Line Sediment Filter Cartridges

PRODUCT DOCUMENTATION

• Omnipure CL6PF5 Sediment Inline Filter (Spec Sheet)
• Omnipure CL10PF5  Sediment Inline Filter (Spec Sheet)

The Omnipure CL Series Inline Sediment Filter Cartridges are available in two sizes: 2” x 6” (CL6PF5 or CL6PF25 ) and 2” x 10” (CL10PF25 or CL10PF25). They have three different FPT in /out ports: (1/8”, 1/4” and 3/8”). The CL Series Sediment in line filters are designed for sediment, dirt and turbidity removal and can be used in icemakers, refrigerators, under the counter, drinking fountains, beverage equipment, Reverse Osmosis (RO) Systems, and in conjunction with commercial purification systems. No glues or binders that may cause contamination are used in the manufacturing process. The components of the Omnipure CL inline filters are friction-welded together insuring a no-leak seal. All filters should be installed on cold water lines only. NOTE: The sediment filters are not intended to be used where the water is microbiologically unsafe or with water of unknown quality without adequate disinfection before or after the unit.

SPECIFICATION 

• CL6PF5: 2"x 6" 5 micron filtration
• CL6PF25: 2"x 6" 25 micron filtration
• CL10PF5: 2"x 10" 5 micron filtration
• CL10PF25: 2"x 10" 25 micron filtration
• Sediment, Dirt and Turbidity Reduction
• Dimensions: 2" x 6" or 2" x 10"
• Ports: A 1/8" FPT, B 1/4" FPT, C 3/8" FPT
• Nominal 5 Micron rating or 25 micron
• Temperature (ºF) (min/max): 35/100
• Pressure (psi) maximum: 125
• Service Flow Rate: 0.75 GPM, (2.7 LPM)
• Note flow direction of filter
• Threaded fittings must be wrapped with Teflon tape before installation
• Install Teflon taped fittings and tighten firmly
• Flush new cartridge with 5 gallons of water prior to use and check for leaks.
• Replace cartridge when rated capacity is reached, or when flow becomes too slow
• Install in compliance with state and local laws and regulations
• Case Quantity;  CL6PF 50 PCs
• Case Quantity;  CL10PF 25 PCs